SIT3808

• ● 1MHz - 80MHz任意频率，可精确到小数点后6位
• ● ±25ppm ~ ±50ppm全温范围频率稳定性
• ● 1.8V，2.5V，2.8V，3.3V工作电压
• ● 牵引范围±50ppm ~ ±1600ppm
• ● 行业标准通用尺寸，完全兼容替代石英VCXO

SiT3808压控晶振具有<1%牵引线性

• ● 软件控制锁相环中更简单的环路控制
• ● 工作范围内更一致的PLL带宽
• ● 更快的校准和锁定时间
• ● 减少调制谐波

SiT3808压控晶振支持可配置驱动力强度

• ● 可配置的上升/下降时间，降低振荡器的EMI
• ● 通过驱动多个负载来节省成本，消除其他计时组件

2520、3225功能引脚

功能引脚示意图	脚位		功能	说明
	1	VIN	Input	0-Vdd: produces voltage dependent frequency change
	2	GND	Power	Electrical ground
	3	CLK	Power	Power supply voltage
	4	VDD	Input Power	Oscillator output power[7]

7. A capacitor value of 0.1 μF between VDD and GND is recommended.

5032、7050功能引脚

功能引脚示意图	脚位		功能	说明
	1	VIN	Input	0-Vdd: produces voltage dependent frequency change
	2	NC/OE/ST	No Connect	H or L or Open: No effect on output frequency or other device functions
			Output Enable	H or Open[8]: specified frequency output  L: output is high
			Standby	H or Open[8]: specified frequency output  L: output is low (weak pull down)[9]. Oscillation stops
	3	GND	Power	Electrical ground
	4	CLK	Output	Oscillator output
	5	NC	No Connect	H or L or Open: No effect on output frequency or other device functions
	6	VDD	Power	Power supply voltage[10]

Notes:
8. In OE or ST mode, a pull-up resistor of 10 kΩ or less is recommended if pin 2 in the 6-pin package is not externally driven. If pin 2 needs to be left floating, use the NC option
9. Typical value of the weak pull-down impedance is 5 mΩ
10. A capacitor value of 0.1 μF between VDD and GND is recommended.