SIT9366

SiT9366低抖动差分晶振在实际运行条件下具有出色的动态性能

• ● 0.23 ps抖动（典型值）
• ● ±10 ppm
• ● 在恶劣环境中具有更好的系统性能

• ● 最大程度减少高振动环境中的数据包丢失

• ● 简化电源设计

• ● 实现具有严格抖动要求的小型系统

• ● 1MHz - 220MHz任意频率，可精确到小数点后6位
• ● 2.5V - 3.3 V工作电压
• ● LVPECL，LVDS，HCSL：定制的振荡器规格，以实现最佳系统性能

• ● 10亿小时的平均无故障工作时间
• ● 终身保修
• ● 减少由于时钟组件和相关维修成本引起的现场故障

功能引脚示意图	脚位	功能		说明
	1	OE	Output Enable	H[5]: specified frequency output  L: output is high impedance
		NC	No Connect	H or L or Open: No effect on output frequency or other device functions
	2	NC	NA	No Connect; Leave it floating or connect to GND for better heat dissipation
	3	GND	Power	VDD Power Supply Ground
	4	OUT+	Output	Oscillator output
	5	OUT-	Output	Complementary oscillator output
	6	VDD	Power	Power supply voltage[6]

Notes:
5.In OE mode, a pull-up resistor of 10 kΩ or less is recommended if pin 1 is not externally driven.
6.A capacitor of value 0.1 μF or higher between VDD and GND is required. An additional 10 μF capacitor between VDD and GND is required for thebest phase jitter performance.